The continued demand for high performance electronic products and the simultaneous trend of miniaturization has raised the dissipated power and power densities to new unprecedented levels in electronic systems. Thermal management is becoming increasingly critical to the electronics industry to satisfy the increasing market demand for faster, smaller, lighter and more cost effective products. Utilization of waste heat for the purpose of cooling chip is a promising area for enhancing the thermal management and net energy efficiency of the system. This paper focuses on the development of a tubular microgrooved evaporator and its performance characterization based on heat transfer coefficients and pressure drop measurements. Channel with aspect ratio of 3:1 (channel width – 100 μm, channel height – 300 μm) microgrooved structure was used in the evaporator. The system has been tested with R134a as refrigerant for refrigerant flow rate range of 0.005–0.02 kg/s and water flow rate range of 0.25–0.65 kg/s. Very promising results has been obtained in preliminary investigation. Heat transfer coefficient as high as 13,500 W/m2k has been obtained which is almost five times higher than comparative state of art technologies. The associated pressure drop is quite modest and much less than state of the art conventional evaporators.
- Electronic and Photonic Packaging Division
High Performance Micro-Grooved Evaporative Heat Transfer Surface for Low Grade Waste Heat Recovery Applications
- Views Icon Views
- Share Icon Share
- Search Site
Jha, V, Dessiatoun, S, Ohadi, M, Shooshtari, A, & Al-Hajri, E. "High Performance Micro-Grooved Evaporative Heat Transfer Surface for Low Grade Waste Heat Recovery Applications." Proceedings of the ASME 2011 Pacific Rim Technical Conference and Exhibition on Packaging and Integration of Electronic and Photonic Systems. ASME 2011 Pacific Rim Technical Conference and Exhibition on Packaging and Integration of Electronic and Photonic Systems, MEMS and NEMS: Volume 2. Portland, Oregon, USA. July 6–8, 2011. pp. 277-283. ASME. https://doi.org/10.1115/IPACK2011-52179
Download citation file: