Skip Nav Destination
1-6 of 6
Keywords: Friction factorClose
Proc. ASME. IMECE2019, Volume 8: Heat Transfer and Thermal Engineering, V008T09A001, November 11–14, 2019
Paper No: IMECE2019-10203
... of 10% variation is observed in friction factor obtained by experimental analysis and Blasius and Petukov correlations. heat transfer enhancement twisted tape twist ratio Nusselt number friction factor NUMERICAL AND EXPERIMENTAL ANALYSIS OF TWISTED TAPE INSERT IN CIRCULAR TUBE V. S...
Proc. ASME. IMECE2019, Volume 8: Heat Transfer and Thermal Engineering, V008T09A002, November 11–14, 2019
Paper No: IMECE2019-10432
... to 60,000. Heat transfer and pressure drop characteristics studied using computational analysis. Nusselt Number and friction factor of round tube with CTT insert is found to be 1.79–1.94 times and 2.5–3.5 times higher respectively compared to round tube without any insert. Thermal performance factor...
Proc. ASME. IMECE2019, Volume 8: Heat Transfer and Thermal Engineering, V008T09A047, November 11–14, 2019
Paper No: IMECE2019-11624
... of both inter-connectors were the same as the mini-channel. Bottom surface temperature, Nusselt number ( Nu ), thermal resistance, and friction factor were calculated to address the effect of the inter-connectors on the overall thermal-hydraulic performance of the heat sink. The results showed that...
Proc. ASME. IMECE2013, Volume 8A: Heat Transfer and Thermal Engineering, V08AT09A032, November 15–21, 2013
Paper No: IMECE2013-63167
... Macroscopic modeling of hydrodynamic behavior of nanofluid flow in a uniformly heated circular pipe is considered. Single-phase models with Brownian and dispersion viscosity models are evaluated by comparing predicted pressure drop and apparent friction factor with experimental and two-phase...
Proc. ASME. IMECE2011, Volume 10: Heat and Mass Transport Processes, Parts A and B, 153-158, November 11–17, 2011
Paper No: IMECE2011-64440
... factor; BPFHE. NOMENCLATURE A: total heat transfer area AC minimum flow area CP specific heat AT constant pressure C1 ,C2 ,C turbulence model constant rh hydraulic radius f friction factor Fp fin pitch Gk turbulent kinetic energy generation term h specific enthalpy hC heat transfer coefficient k...
Proc. ASME. IMECE2006, Fluids Engineering, 239-242, November 5–10, 2006
Paper No: IMECE2006-13126
... 12 02 2008 An alternative to the traditional friction factor for pipe flow is presented (φ = [ R ] f ). For incompressible flows, the correlation of this new friction factor with Reynolds Number [ R ] and Relative Roughness [ε] is presented graphically, and appears much simpler and...