Scanning Electron Microscopy and Optical Profilometry of Electropolished Additively Manufactured 316 Steel Components

Additive manufacturing (AM) can produce highly complex engineering components that are either extremely challenging for the conventional subtractive manufacturing route or not possible otherwise. High surface roughness can make an AM component highly vulnerable to premature failure during fatigue loading. Post-processing aiming to reduce surface roughness is essential to make as produced AM parts functional. We have explored electropolishing route to achieve optimum surface roughness and surface chemistry. We have performed electropolishing treatment on the steel AM parts around 70 °C in an electrolyte comprising the phosphoric acid and sulfuric acid. Profilometry and scanning electron microscopy were performed to study the electropolished and unpolished areas. Optical profilometry study showed that one needs to remove nearly ∼200 μm material from the surface to achieve very smooth surface. Electropolishing was effective in reducing the surface Ra roughness from ∼2 μm rms to ∼0.07 μm rms. Such low rms roughness makes an AM component suitable for almost every engineering application for which a smooth surface is required. Scanning electron microscopy revealed that electropolished area on AM component possessed distinctively different microstructure as compared to the untreated surface of an AM component. We also conducted the compositional analysis of the electropolished area to investigate the possibility of residual contamination from the electropolishing process. Our study revealed that electropolishing is a highly promising route for improving the surface finishing of AM components.