Systemic experiments were conducted for the spray cooling of high temperature stainless steel using three different types of industrial sprays, full cone and flat hydraulic nozzles and a flat air-mist nozzle. In the present study wide range of mass flux (1.5-30 kg/m2sec) is covered, which has never been thoroughly investigated before. Orientations with respect to gravity and spray angle were also explored. The data have been analyzed and correlated. The results of this study will be important to the product quality control in industries by providing a good estimate of heat flux at different mass flux, spray types and surface temperatures, especially for spray cooling of stainless steel and other metals with similar thermal properties.
Volume Subject Area:
Heat Transfer
1.
Cox, T., “Heat Transfer Experiments and General Correlation for Sprays of Very large Droplets Impinging on a Heated Surface,” Doctoral thesis, Mech. Eng. Dept., Carnegie Mellon University, Feb., 1998
2.
Choi
K. J.
Yao
S. C.
Heat Transfer Mechanisms of Horizontally Impacting Spays
,” Int. J. Heat Mass Transfer
, Vol. 30
(2)
, pp. 1291
–1296
, 1987
.3.
Dep
S.
Yao
S. C.
Analysis on Film Boiling Heat Transfer of Impacting Sprays
,” Int. J. Heat and Mass Transfer
, v. 32
n.11
, pp. 2099
–2112
, 1989
4.
Gaugler, R.E., “Experimental Investigation of spray Cooling of High Temperatutre Surfaces,” Doctoral thesis, Mech. Eng. Dept., Carnegie Mellon university, July (1966).
5.
Hoogendoorn
C. J.
Hord
R. D.
Leidenfrost temperature and heat transfer coefficients for water sprays impinging on a hot surface
,” Proceedings, Fifth Int. Heat Transfer Conference
, Vol. 4
, pp. 135
–138
, 1974
6.
Mizikar, E., “Spray Cooling Investigation for Continuous Casting of Billets and Blooms”, Iron and Steel Engineer, pp.53–70 June, 1970
7.
Bolle, L., and Moureau, J. C., “Spray Cooling of Hot Surfaces,” Multiphase Science and Technology, Hemisphere, 1982
8.
Mudawar
I.
Valentine
W. S.
Determination of Local Quench Curve for Spray_cooled metallic Surfaces
,” J. Heat Treating
, vol. 7
, no. 2
, pp 107
–121
, 1989
9.
Klinzing
W. P.
Rozzi
J. C.
Mudawar
I.
Film and transition Boiling Correlations for Quenching of hot Surface with Water Sprays
,” J. Heat Treating
, vol. 9
, no. 2
, pp 91
–103
, 1992
10.
Stewart, I., and Massingham, J. D., “Heat Transfer Coefficient Effects on Spray Cooling,” Iron and Steel Engineer, pp.17–23, July, 1996
11.
Weber
C. F.
Analysis and solutions of ill-posed inverse heat conduction
,” Int. J. Heat Mass Transfer
, v.24
, pp 1783
–1792
, 1981
12.
Figliola, R. S., and Beasley, D. E., Theory and Design for Mechanical Measurements, John Wiley & Sons, Inc., 2nd Edition, 1995
13.
Chapman, A. J., Fundamentals of Heat Transfer, Macmillan Publishing Company, New York, 1987
This content is only available via PDF.
Copyright © 2006
by ASME
You do not currently have access to this content.