This work investigates the nonlinear vibration of gear pairs, where the nonlinearity is due to portions of gear teeth contact lines losing contact (partial contact loss). The gears are modeled as rigid bodies that admit motion in six degrees of freedom. A network of distributed stiffnesses models the nonlinear gear contact. The distributed stiffness scheme is obtained by discretizing the kinematic contact lines into segments, each with the possibility of losing contact. Whether these segments are actually in contact or not is determined by the gear deflections and tooth modifications. The modeling is verified with finite element analysis and experimental measurements from the literature. The combination of a translational and a tilting spring is proven to be identical to the distributed stiffness model. This equivalent representation of the mesh identifies a nonlinear tilting mesh stiffness that accompanies the well-known translational gear mesh stiffness typically modeled by a single spring. Modal analysis reveals a mesh tilting vibration mode where this spring dominates, in addition to the mesh deflection vibration mode. Computational dynamic analysis of a helical gear pair near the natural frequencies of the mesh tilting and deflection modes exhibit nonlinear vibrations. Both cases involve nonlinearity due to partial contact loss where only part of a nominal contact line loses contact at an instant.
- Design Engineering Division and Computers in Engineering Division
Computational Nonlinear Vibration Analysis of Gear Pairs Using a Three-Dimensional Model
- Views Icon Views
- Share Icon Share
- Search Site
Eritenel, T, & Parker, RG. "Computational Nonlinear Vibration Analysis of Gear Pairs Using a Three-Dimensional Model." Proceedings of the ASME 2009 International Design Engineering Technical Conferences and Computers and Information in Engineering Conference. Volume 6: ASME Power Transmission and Gearing Conference; 3rd International Conference on Micro- and Nanosystems; 11th International Conference on Advanced Vehicle and Tire Technologies. San Diego, California, USA. August 30–September 2, 2009. pp. 149-165. ASME. https://doi.org/10.1115/DETC2009-87485
Download citation file: