Transmission Error in Helical Synchronous Belt Drives in Bidirectional Operation: Influence of Pulley Flange Under No Load Available to Purchase

Helical synchronous belt drives are more effective than conventional synchronous belt drives with respect to reducing noise and transmission error per single pitch of the pulley. However, the helix angle of the tooth trace causes axial belt movement. Therefore, a flanged pulley is used in a helical synchronous belt drive. In the present study, the transmission error in a helical synchronous belt drive using a flanged pulley under installation tension was investigated both theoretically and experimentally for the case where the pulley was rotated in bidirectional operation. The computed transmission error agrees well with the experimental results, thereby confirming the applicability of the proposed theoretical analysis for transmission error. In this case, transmission error is found to be generated by the difference in axial belt movement between the driving and driven sides, and by a change in the state of contact between the belt and pulley teeth flanks. The transmission error is reduced when the installation tension is set higher than the tension that causes a change in contact direction between the tooth flanks. In addition, transmission error does not occur when the driving and driven pulleys are of equal outside diameter and have no pulley alignment error.