Abstract

If an accident occurred in a plant in lower power operation, a series of problems could be caused by low residual heat and excessive removal capability of heat sinks. Taking a real accident as example, this paper discussed how to deal with loss of normal feedwater in AP1000 NPP during lower power operation. The level of Steam Generators (SG) will be rapidly reduced in case of Main Feedwater loss, and Startup Feedwater pump will start. If the reactor is not shut down immediately, the Startup Feedwater will not be enough to prevent SG level from falling, and automatic reactor trip will be inevitable. Therefore, in event of loss of Main Feedwater which cannot be recovered instantly, the reactor should be shut down manually to maintain SG level as high as possible. Appropriate measures should be taken to avoid excessive cooling after trip. Attention should be paid to SG level and feedwater flow to avoid Passive Residual Heat Removal Heat Exchanger (PRHR HX) actuation during regulating Startup Feedwater. Otherwise, PRHR HX may be actuated unexpectedly. With Reactor Coolant Pumps operating, PRHR HX heat removal capacity is strong. The Cold Leg temperature will drop rapidly because of PRHR HX and other heat sinks. In this case, the most effective measure to stabilize temperature of Cold legs is to isolate Streamline. Otherwise, structure integrity of the Reactor Pressure Vessel (RPV) will be challenged under Pressurized Thermal Shock (PTS) due to rapid drop of Cold leg temperature. In order to alleviate PTS, depressurization shall be performed and further cooling shall be suspended. Since PRHR HX is only connected to Loop 1, coolant in Hot Leg of Loop 2 is still kept at high temperature. Therefore, necessary measures shall be taken to prevent coolant flash in Loop 2 during the process of depressurization, which may fill the Pressurizer up with water. The RPV Head Vent valves perform safety-related function by preventing Pressurizer overfill in certain design basis events in AP1000 NPP. However, emergency letdown by opening the valves cannot effectively reduce Pressurizer level when coolant flashed in Loop 2. Because of mitigating PTS, opening RPV Head Vent valves, and steam condensation in Loop 2, the subcooling of the coolant at the core outlet is likely to drop below 6 °C or even 0 °C.

This content is only available via PDF.
You do not currently have access to this content.