Usually the plus of the voltage-preamplifier we used is changeless or 2-modes (×1 or ×10), and the value is low (×10). But in the practical application, the energy of the particles detected are complicated. Especially, when the particles which are detected are unknown, it will be advantageous to the result to select a proper plus. So it will be great beneficial for the practical application to design a bran-new voltage-preamplifier which has bigger plus comparing to the amplifier we used now and could select a proper plus for the experiment automatically. This article introduces a design of a kind of new voltage-preamplifier with a bigger plus (×20) than traditional voltage-preamplifiers and whose plus can be controlled continuously. The most important of all is that this voltage-preamplifier can select a appropriate plus for the experiment automatically by the order of the handlers. It adjusts the plus by the information from the sensor to the order. In this design we control the output-signal from 100∼200 mV. And then, this paper introduces the simulation of the amplifier’s working process by Multisim10.0 and Multisim10.0 Proteus ISIS.
Skip Nav Destination
18th International Conference on Nuclear Engineering
May 17–21, 2010
Xi’an, China
Conference Sponsors:
- Nuclear Engineering Division
ISBN:
978-0-7918-4929-3
PROCEEDINGS PAPER
The Design and Simulation of Voltage-Preamplifier With Numerical-Controlled Plus Available to Purchase
Wenyan Ma,
Wenyan Ma
Second Artillery Engineering College, Xi’an, Shanxi, China
Search for other works by this author on:
Guojian Yu,
Guojian Yu
Second Artillery Engineering College, Xi’an, Shanxi, China
Search for other works by this author on:
Jian Chang
Jian Chang
Second Artillery Engineering College, Xi’an, Shanxi, China
Search for other works by this author on:
Wenyan Ma
Second Artillery Engineering College, Xi’an, Shanxi, China
Guojian Yu
Second Artillery Engineering College, Xi’an, Shanxi, China
Jian Chang
Second Artillery Engineering College, Xi’an, Shanxi, China
Paper No:
ICONE18-29512, pp. 711-713; 3 pages
Published Online:
April 8, 2011
Citation
Ma, W, Yu, G, & Chang, J. "The Design and Simulation of Voltage-Preamplifier With Numerical-Controlled Plus." Proceedings of the 18th International Conference on Nuclear Engineering. 18th International Conference on Nuclear Engineering: Volume 1. Xi’an, China. May 17–21, 2010. pp. 711-713. ASME. https://doi.org/10.1115/ICONE18-29512
Download citation file:
7
Views
Related Proceedings Papers
Related Articles
Lattice Boltzmann Simulation of Lithium Peroxide Formation in Lithium–Oxygen Battery
J. Electrochem. En. Conv. Stor (August,2016)
Heat Transfer in Wire Bonding Process
J. Electron. Packag (March,1994)
Reduced Model and Application of Inflating Circular Diaphragm Dielectric Elastomer Generators for Wave Energy Harvesting
J. Vib. Acoust (February,2015)
Related Chapters
Introduction
Vibrations of Linear Piezostructures
Fatigue Life Prediction and Experimental Verification for an Automotive Suspension Component Using Dynamic Simulation and Finite Element Analysis
Advances in Fatigue Lifetime Predictive Techniques
The Influence of Current Supply Type and Arc Length on C-Mn, C-Mn-Ni, and C-Mn-Ti-B Shielded Metal Arc Deposit Nitrogen and Oxygen Contents
Residual and Unspecified Elements in Steel