A model has been developed for predicting the amount of condensate retained as drops on the air-side of heat exchangers operating under dehumidifying conditions. For a coil with a given surface wettability, characterized by the advancing contact angle, the maximum diameter for a retained drop is obtained from a balance between gravitational and surface tension forces. A logarithmic function is used to describe the size-distribution of drops on fins, based on the fraction of fin-area covered by liquid. The volumes of individual drops are calculated by a geometric method for approximating the three dimensional shapes of drops on vertical and inclined surfaces. The total volume of condensate accumulated on a coil is then found by multiplying the size-distribution and volume functions and integrating over all drop diameters. The model is successful in predicting measurements by other researchers of the mass of condensate retained on plain-fin heat exchangers.

This content is only available via PDF.
You do not currently have access to this content.