Evaporation cooling increases gas turbine power output. Experimental results suggest an 8% increase of power when 1% of the overall mass flow is added via water droplets injected upstream of the compressor. However, water injection has an impact on the flow field, which requires experimental research involving probe measurements in the droplet-laden flow as well as reliable monitoring during operation, as the volumetric flow rate throughout the stages changes notably and deviates from (dry) design parameters. Measuring with a conventional pressure probe in two-phase flows is challenging because the droplet-laden flow can clog the pressure taps, thus effectively separating the sensor from the measurement location. This paper presents a consistent approach to measure stagnation pressure in a droplet-laden flow field. The probe was purged constantly to prevent droplets from clogging the tubing. The recorded pressure is then corrected using a transfer function to account for the purging pressure offset. A detailed description of how to obtain this function is given within the paper. With this setup, the flow field downstream of a blade cascade was measured at several water mass fractions and spray characteristics. The pressure measurements are compared with the usual LDA/PDA measurements in the wake of the cascade. Based on the test results, an evaluation of the change of total-head loss due to water injection and evaporation compared to dry operation can be performed.

This content is only available via PDF.
You do not currently have access to this content.