Film cooling represents one the most widely-used cooling techniques for hot gas path components. In particular, effusion cooling has recently become an important focus of attention in the context of aero-engine design due to its high cooling performance. Notwithstanding the huge amount of work dedicated to the heat transfer on the hot side of effusion cooling plates, it has been demonstrated that up to 30 % of the total cooling effectiveness of a typical effusion cooling configuration can be ascribed to cold side convective cooling. Nevertheless, in open literature it is possible to notice a lack of knowledge as far as this topic is concerned.
This paper describes a numerical activity aimed at investigating the phenomenology of the heat transfer at the entrance of film cooling holes. First of all the accuracy of the numerical approach has been validated through a comparison of enhancement factor measurements on a test case available in literature. Steady state RANS simulations have been performed, modeling turbulence by means of the k–ω SST model. The use of a transition model has been taken into account, since in these configurations the transitional behavior of the boundary layer has been highlighted in literature. Subsequently, the attention has been turned to the comprehension of the phenomena involved in the heat transfer augmentation, focusing the attention to the influence of fluid dynamic parameters such as suction ratio and Reynolds number. A good agreement has been highlighted with experimental data, therefore this work provides a starting point for future investigations on more representative configurations.