Loss Reduction in Compressor Cascades by Means of Passive Flow Control

Secondary flow effects like the corner stall between the wall and the vane in a compressor stage are responsible for a large part of total pressure losses. An extensive experimental study of flow control in a highly loaded compressor cascade was performed in order to decrease the separation and reduce the losses by means of vortex generators. The vortex generators were attached at the surface of the cascade side walls. These flow control devices produce strong vortices, which enhance the mixing between the main flow and the decelerated boundary layer at the side wall. Thus, the corner flow separation and the total pressure losses could be reduced. The experiments were carried out with a compressor cascade at a high-speed test facility at the DLR in Berlin at minimum loss (design point) and off-design of the cascade at Reynolds numbers up to Re = 0.6 × 10⁶ (based on 40 mm chord) and Mach numbers up to M = 0.7. The cascade consisted of five vanes. The blade profiles are comparable to the hub section of the stator vanes used in the transonic compressor test rig running at Technische Universita¨t Darmstadt. In the range between −2° and +4° angle of incidence the total pressure losses of the cascade could be reduced up to 4.6% by means of vortex generators, whereas the static pressure rise was not influenced. Based on the results of the cascade measurements, the vortex generators were applied in front of the stator row of the single stage axial compressor at Technische Universita¨t Darmstadt. A numerical simulation of the compressor flow provided an indication for the adjustment of the vortex generators at the hub and casing. In the experiments the pressure rise and the efficiency of the axial compressor was measured and it could be shown that vortex generators partially improve the efficiency.