To cover the increasing demand of on-board electrical power and for further reduction of emissions, the conventional auxiliary power unit (APU) may be replaced by a fuel cell system with an expected efficiency increase of 25% to 50% when compared to start-of-the-art GT-APU. The main components of an in-flight FC system are a compressor-turbine unit, a kerosene reformer, and the fuel cell. Polymer exchange membrane fuel cells (PEM-FC) may be favored because of their currently advanced level of development, their high power density and the available liquid water in the cathode-off gases which can be used as service water on-board. Transient requirements may have significant impact on system design and operating range and will therefore be addressed in this paper. During in-flight operation, air has to be compressed from the ambient to a pressure near standard conditions, which allows the application of state-of-the-art PEM-FC and ensures a constant power density independent from the operating altitude. A centrifugal compressor is chosen for pressurization of the system and is powered by a radial turbine, which allows autonomous operation at cruising altitude without external power. For off-design operation and transients, electric support from the PEM-FC is necessary, see [1]. The radial turbine itself is run by the hot exhaust gases from a post-combustor using the remaining energy in the cathode off-gases. A thorough trade-off between suitable compressor techniques for the air supply system was carried out in [1]. Turbomachinery revealed to be favourable for the PEM air supply system due to their low specific weight and high efficiency. The air supply system resembles the turbocharger for a combustion engine (Fig. 1), which represents a good starting point for a successful integration into the flight environment and further development due to known technology. Based on a turbomachinery design which satisfies the system requirements, the dynamic behavior of the air supply system is analyzed when coupled to the PEM fuel cell. The main focus is on the detection of sensitive system parameters causing system response delay or critical operating conditions. The present paper suggests system features, turbomachinery design parameters and controller types which achieve inherent stability and fast response of the air supply system throughout the entire flight envelope.
Skip Nav Destination
ASME Turbo Expo 2007: Power for Land, Sea, and Air
May 14–17, 2007
Montreal, Canada
Conference Sponsors:
- International Gas Turbine Institute
ISBN:
0-7918-4792-6
PROCEEDINGS PAPER
Dynamic Modelling and Controls of an Air Supply System for In-Flight Proton Exchange Membrane Fuel Cells (PEM-FC) Available to Purchase
Lukas P. Barchewitz,
Lukas P. Barchewitz
University of Hannover, Hannover, Germany
Search for other works by this author on:
Joerg R. Seume
Joerg R. Seume
University of Hannover, Hannover, Germany
Search for other works by this author on:
Lukas P. Barchewitz
University of Hannover, Hannover, Germany
Joerg R. Seume
University of Hannover, Hannover, Germany
Paper No:
GT2007-27900, pp. 363-372; 10 pages
Published Online:
March 10, 2009
Citation
Barchewitz, LP, & Seume, JR. "Dynamic Modelling and Controls of an Air Supply System for In-Flight Proton Exchange Membrane Fuel Cells (PEM-FC)." Proceedings of the ASME Turbo Expo 2007: Power for Land, Sea, and Air. Volume 3: Turbo Expo 2007. Montreal, Canada. May 14–17, 2007. pp. 363-372. ASME. https://doi.org/10.1115/GT2007-27900
Download citation file:
26
Views
Related Proceedings Papers
Related Articles
Performance Assessment of Turbocharged Pem Fuel Cell Systems for Civil Aircraft Onboard Power Production
J. Eng. Gas Turbines Power (March,2008)
Analysis and Optimization of Transient Response of Polymer Electrolyte Fuel Cells
J. Fuel Cell Sci. Technol (February,2015)
Enhancing Polymeric Electrolyte Membrane Fuel Cell Control by Means of the Perturb and Observe Technique
J. Fuel Cell Sci. Technol (February,2010)
Related Chapters
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Combined Cycle Power Plant
Energy and Power Generation Handbook: Established and Emerging Technologies
Lay-Up and Start-Up Practices
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration