Effect of Bubble Size and Angle of Tapered Upriser Pipe on the Effectiveness of a Two Phase Lifting Pump Available to Purchase

Two phase lifting pumps are devices with the ability of lifting liquid phase by injecting the gas phase. Parameters which affect the performance of these pumps are divided into two groups. The first group contains design parameters such as diameter of the pipe, tapering angle of the upriser pipe and the submergence ratio which is the ratio of immersed length to the total length of the upriser. The second group includes operating parameters, such as the gas flow rate, bubble diameter, bubble distribution and inlet gas pressure. In this research, the performance of two phase lifting pump is investigated numerically for different submergence ratios and different diameter of the upriser pipe. For this purpose the two phase pump with a riser length of 914 mm and different diameters (6, 8 and 10 mm), and seven tapering angles (0°, 0.25°, 0.5°, 1°, 1.5°, 2° and 3°) are numerically modeled and analyzed. Different submergence ratios are used, namely: 0.4, 0.6 and 0.8. The numerical results are compared with the existing experimental data in the literature showing a reasonable agreement. The results indicate that decrease in size of the bubble diameter increases mass flow rate of liquid at constant submergence ratios. The present study reports the improved performance of this pump with decrease in bubble size and increase in angle of tapered upriser pipe. Moreover, the results show that the tapered upriser pipe with 3° tapering angle gives the highest efficiency at nearly all submergence ratios. Further, the highest efficiency of the pump is shown to be at the largest submergence ratio, namely 0.8.