The development of new temperature-dependent phosphor particles for high temperature thermometry is presented. To develop the phosphor material that can be applied to the intensity ratio method, the photoluminescence of Y2O3:Tb,Tm was investigated with elevating temperature. As a result, Y2O3:Tb,Tm phosphor shows that the peak intensity at 456 nm is still strong at more than 1100 K whereas the other peak intensities decrease due to the thermal quenching. Thus, the intensity ratio I543nm/I456nm has a high gradient and linearity over a wide temperature range, and it is confirmed that Y2O3:Tb,Tm provides a higher resolution in temperature measurement than Y2O3:Tb and Y2O3:Tm. Also, since this phosphor changes its emission color from green to blue with increasing temperature, it is possible to measure temperature not only by analyzing the intensity ratio but also by observing the color change in appearance. It can, therefore, be expected to use as a Visual Thermo-Sensor (VTS).
Skip Nav Destination
ASME/JSME 2011 8th Thermal Engineering Joint Conference
March 13–17, 2011
Honolulu, Hawaii, USA
Conference Sponsors:
- Heat Transfer Division
ISBN:
978-0-7918-3892-1
PROCEEDINGS PAPER
Phosphor Thermometry by Using Rare Earth-Doped Yttrium Oxides
Naohiro Ishiwada,
Naohiro Ishiwada
Keio University, Yokohama, Kanagawa, Japan
Search for other works by this author on:
Satoko Fujioka,
Satoko Fujioka
Keio University, Yokohama, Kanagawa, Japan
Search for other works by this author on:
Toshihisa Ueda,
Toshihisa Ueda
Keio University, Yokohama, Kanagawa, Japan
Search for other works by this author on:
Takeshi Yokomori
Takeshi Yokomori
Keio University, Yokohama, Kanagawa, Japan
Search for other works by this author on:
Naohiro Ishiwada
Keio University, Yokohama, Kanagawa, Japan
Satoko Fujioka
Keio University, Yokohama, Kanagawa, Japan
Toshihisa Ueda
Keio University, Yokohama, Kanagawa, Japan
Takeshi Yokomori
Keio University, Yokohama, Kanagawa, Japan
Paper No:
AJTEC2011-44287, T10160; 6 pages
Published Online:
March 1, 2011
Citation
Ishiwada, N, Fujioka, S, Ueda, T, & Yokomori, T. "Phosphor Thermometry by Using Rare Earth-Doped Yttrium Oxides." Proceedings of the ASME/JSME 2011 8th Thermal Engineering Joint Conference. ASME/JSME 2011 8th Thermal Engineering Joint Conference. Honolulu, Hawaii, USA. March 13–17, 2011. T10160. ASME. https://doi.org/10.1115/AJTEC2011-44287
Download citation file:
13
Views
Related Proceedings Papers
Related Articles
Temperature Measurements Using a High-Temperature Blackbody Optical Fiber Thermometer
J. Heat Transfer (June,2003)
Heat flux determination from measured heating rates using thermographic phosphors
J. Heat Transfer (June,2005)
Gas Temperature Measurements in High Concentration Solar Furnace Environments: Evidence of Nonequilibrium Effects
J. Sol. Energy Eng (November,2007)
Related Chapters
Cooling a Radar’s Electronic Board
Electromagnetic Waves and Heat Transfer: Sensitivites to Governing Variables in Everyday Life
Adaptive Grayscale Morphological Operators for Image Analysis
Intelligent Engineering Systems Through Artificial Neural Networks, Volume 17
Application of Adaptive Grayscale Morphological Operators for Image Analysis
Intelligent Engineering Systems through Artificial Neural Networks Volume 18